How To Assemble Fingerboard
It is quite easy to assemble fingerboard step by step.
Step 1:
Attach the fingerboard truck to the deck with the 8 screws provided. It is a good idea to place the screws in the truck before attaching them to the deck. Remove the screws and attach the truck to the deck. The truck is not pre-threaded. This is normal for all fingerboard trucks.
Step 2:
Make sure the screws go through the fingerboard truck. If the screws are not tight, the truck will fall off. If you have difficulty in a truck, it's better to put the screws in the truck before connecting them to the deck. Remove the screws and attach the truck to the deck. The truck is not pre-threaded. This is normal for all fingerboard trucks.
Step 3:
Place the wheel on the axle. The wide side of the wheel faces outward.
Place the nut in the tool and tighten the wheel to the axle. Ensure that the nut is tight but does not prevent the wheel from turning.
Step 4:
Remove the backing from the foam tape, as shown.
Step 5:
Use a nail file or fine sandpaper to remove excess foam tape.